Implant Preparation Procedures
Bone Augmentation

Tooth loss occurs for many reasons; dental decay, root canal problems, fractures, periodontal disease and trauma. Additionally, at times teeth never develop. As a result of tooth loss, the bone melts away.

Bone grafting materials are used to rebuild and regenerate the bone providing sufficient bone in quantity and quality for implant placements and supporting tooth structure.

Bone Grafting

Bone grafting is commonly performed by an oral and maxillofacial surgeon to replace or augment bone in areas of tooth loss. Bone grafting to the jaws and facial structures may be necessary in a wide variety of scenarios. The most common bone grafts are facial skeleton and jaw procedures. Other common procedures include tooth extraction site graft, bone graft reconstruction and for a sinus lift. Shrinkage of bone often occurs when a tooth is lost due to trauma, severe caries, or periodontal disease. Additionally, bone loss may have already occurred due to infection or pathology around a tooth. There are many artificial biocompatible bone substitutes available; however, the best material for a bone graft is your own bone, which most likely will come from your chin, the back part of your lower jaw or your hip bone. The hip is considered to be a better source because the hip bone has a lot of marrow, which contains bone-forming cells. There are also synthetic materials that can be used for bone grafting. Most bone grafts use a person's own bone, possibly in combination with other materials.

To place the removed bone in the recipient site, little holes are drilled in the existing bone to cause bleeding. This is done because blood provides cells that help the bone heal. The block of bone that was removed will be anchored in place with titanium screws. A mixture of the patient's bone marrow and some other bone-graft material will then be placed around the edges of bone block. Finally, a membrane is placed over the area and the incision closed.

The bone graft will take about 6 to 12 months to heal before dental implants can be placed. At that time, the titanium screws used to anchor the bone block in place will be removed before the implant is placed.

Ridge Regeneration

When a tooth is lost and not immediately replaced, the bone reacts to this event by 'shrinking back'. The bone becomes thinner from a width perspective and the bone height is frequently reduced. This process is known as bone resorption. In order to place implants, it is necessary to rebuild the bone width and height through regenerative surgical therapy. Bone grafting of the ridge is almost always required to enable accurate placement of dental implants. The grafting is completed utilizing tissue bank and/or synthetic bone particles combined with collagen membranes. It is a highly predictable procedure.

Sinus Lift

In the back of the upper jaw bone, dental implants are frequently needed. In order for a dental implant to be successful in this area of the mouth, there must be sufficient bone height and width to connect (integrate) to the dental implant. When the upper back teeth are lost and not replaced, the sinus cavity becomes enlarged destroying any bone that is left behind. This very large sinus is like a "giant air pocket" and not capable of supporting an implant. A procedure known as sinus grafting (sinus lift) is performed to create bone that will ultimately hold the implants within the sinus. Sinus grafting is an extremely common form of bone grafting.

Sinus Graft
Sinus Graft

In the back of the upper jaw bone dental implants are frequently needed. In order for a dental implant to be successful in this area of the mouth there must be sufficient bone height and width to connect (integrate) to the dental implant. When the upper back teeth are lost and not replaced the sinus cavity becomes enlarged destroying any bone that is left behind. This very large sinus is like a "giant air pocket" and not capable of supporting an implant. A procedure known as sinus grafting (sinus lift) is performed to create bone that will ultimately hold the implants within the sinus. Sinus grafting is an extremely common form of bone grafting.

Socket Regeneration

When a tooth is extracted and an implant is to be placed (either simultaneously or in the future) it is always necessary to complete bone grafting within the residual sockets that are left behind after the roots of the tooth are removed. The shape of the tooth root is always different from the shape of a dental implant and hence there are always residual socket defects (holes) that must be filled in so that there can be excellent contact of the implant to the newly formed bone.

15 Minutes from Minneapolis

Thomas Hoover, DDS PA would love to meet you and your family to provide you with the periodontal dental care you need and give you all the smiles you deserve at our St. Louis Park periodontics office!

Or call us today at:
(952) 920-9209